Ionospheric F2-Layer critical frequency retrieved from COSMIC radio occultation: A statistical comparison with measurements from a meridional ionosonde chain over Southeast Asia

In this paper, we compared the F2-Layer critical frequency (foF2) derived from FORMOSAT-3/COSMIC radio occultation (RO) and ionosondes at Chiang Mai, Chumphon and Kototabang during the years 2008–2015 to evaluate the performance of COSMIC RO over Southeast Asia region. The results show that the time development of foF2 values derived from COSMIC RO generally agrees well with those from ionosonde measurements. However, the differences between the foF2 derived from COSMIC RO and that derived from ionosonde observations display latitudinal dependence. COSMIC RO tends to underestimate foF2 at Chiang Mai and Kototabang, which is near to the north EIA crest and the south one, respectively, while a little overestimate foF2 at Chumphon, which is close to the geomagnetic equator. COSMIC RO agrees best with ionosonde at Chumphon and worst at Chiang Mai. At each ionosonde station, the quality of COSMIC RO data degrades with the increase of solar activity. In addition, at the station Chiang Mai and Kototabang, COSMIC RO performs better in summer than in equinox and winter. Furthermore, the differences in foF2 derived from COSMIC RO and that from ionosonde measurements vary with local time, i.e., the differences in foF2 are generally smaller at night and larger in noontime when equatorial ionization anomaly (EIA) is well developed.     

基于锁相环的光电振荡器频率稳定化研究

通过构建小数分频锁相环,将一个工作于X波段的OEO(OptoElectronic Oscillator,光电振荡器)与OCXO(Oven-Controlled Crystal Oscillator,恒温晶体振荡器)进行锁相,得到了输出信号相位噪声和长期频率稳定度的提升。从PLL(Phase-Locked Loop,锁相环)环路传输特性出发,理论分析了PLL输出信号环路带宽内相位噪声水平和作用范围。为降低OEO整体的相位噪声,采用SIL(Self-Injection-Locking,自注入锁定)使OEO在10Hz~10kHz频偏处的相位噪声得到20dB以上的抑制。在此基础上将此SIL OEO与一个频率为100 MHz的OCXO锁相,获得了频率为9.95GHz、相位噪声为-55dBc/Hz@10Hz和-124dBc/Hz@10kHz的微波信号输出,其频率的重叠阿伦方差在100s平均时间内达到1.14×10~(-11),证明了提出的方案对提升OEO频率稳定性具有一定的实际意义。     

采用霍尔传感器的旋翼频率采集设计

为达到对旋翼飞机的控制,需要对旋翼转速进行采集.霍尔转速传感器以其高可靠性等优点常被用来测量转速.介绍了一种使用霍尔传感器进行旋翼转速采集系统,包括硬件构架,逻辑采集单元和软件设计,并给出了优化策略;通过试验数据分析,采集精度达到了预期.     

基于分频段加权的加速振动试验方法

振动环境工程研究现行采用的加速试验方法中,都只考虑了加速因子与频率无关这种情形,这不仅提高了试验设备的推力要求,也增加了位移指标要求。文章提出了一种分频段加权的加速振动试验方法,即通过对低频段加速因子的权重的优化设计,实现较小的位移指标要求,且疲劳损伤累积等效。给出了基于Dirlik方法和TB方法疲劳损伤等效的加速试验设计方法和工程实现流程。针对该方法开展了应用实例的计算,结果表明:在疲劳损伤等效的前提下,显著降低了振动台的位移,且推力基本维持不变。     

带凸肩叶片的断裂故障分析

某型发动机风扇带凸肩的转子叶片发生断裂故障。断口分析表明其为疲劳裂纹特征,其疲劳源在叶盆侧凸肩工作面下侧靠近叶片前缘位置。根据微观分析结论,建立了风扇叶片三维实体模型,利用有限元方法分析了叶片的振动模态。结果表明：叶片在工作时,由于结构的激振可能发生某些阶次的共振,其应力分布与断口分析结果较一致,初步判断叶片是由于共振而发生了疲劳断裂。     

基于中介理论与交通特性的终端区态势评价

终端区交通态势的准确度量是制定并实施流量管理措施的重要依据之一。通过提取终端区宏观与微观的交通特性,从进离场及总量3个维度构建态势的指标描述,并进一步采用中介理论中的真值程度度量与熵权法建立了一种客观的终端区飞行区交通态势模糊综合评价方法,实现客观、准确的交通态势判别与样本间量化比较。选取国内典型繁忙终端区的实测数据,验证了评价方法与特性指标的有效性。     

RFID技术在航空领域的应用研究

射频识别(RFID)技术现已广泛用于物流、金融、零售等各个行业.航空领域的RFID应用起步较晚,通过对RFID技术在飞机制造商、原始设备生产厂家(OEM)、航空公司的一些典型的应用案例的分析,提出RFID技术应用于航空领域所面临的挑战及必要性,为其未来航空业自动识别技术的发展指明了方向.     

不同钝体宽度下的驻涡燃烧室排放试验

为了研究空气流量分配对驻涡燃烧室对排放特性的影响,了解对驻涡燃烧室内污染物生成的过程及其影响因素,设计了一个能够改变中心钝体宽度、仅凹腔供油的驻涡燃烧室.在常压下对该驻涡燃烧室进行了排放特性试验,进口温度保持200℃.试验中,燃烧室进口马赫数为0.15~0.3.影响排放的因素主要包括雾化质量、凹腔当量比以及与进口马赫数相关的驻留时间等.总体来说雾化质量、凹腔当量比的提高对降低CO和HC的排放是有利的,但是这会使NOx排放增加.在低凹腔当量比时,CO排放曲线变化下降比较平缓,甚至出现上升趋势,而HC排放曲线比较陡峭.这是由于HC的消耗速度比CO消耗速度快,随着凹腔当量比的增加,供油压力提高,燃油雾化粒径变小,燃油蒸发时间缩短,使HC排放快速减少,中间产物CO大量产生而来不及消耗.凹腔当量比进一步上升时,由于燃烧温度的提高,使得CO排放快速减少.在燃烧室内燃烧过程中,NOx的形成和消耗是非常复杂的过程,目前只能作一些定性的分析,而CO和HC的反应过程相对简单.通过对不同钝体槽宽下,具有相似凹腔前壁流量的工况的比较,发现CO和HC的形成主要受凹腔内工作状况影响,而NOx的形成过程更复杂,主流也对其产生着重要的影响.      

Effects of synthetic jet frequency on the separated flow in a diffusing S-duct

Numerical simulations were carried out to investigate the effects of synthetic jet actuation frequency on the separated flow in a diffusing S-duct. The Reynolds number based on the entrance height was 9.78×105. At first, the numerical model was validated with experimental data, and then, the interaction between the separated flow and the synthetic jets at different frequencies was discussed. The results demonstrate that the control effect is significantly dependent on the momentum mixing enhancement between inside of the separated boundary layer and the outer flow. There exists a narrow range of actuation frequency, in which effective separation control can be achieved using synthetic jets. A dimensionless frequency F+=1.0 is identified as the optimal frequency, with a momentum coefficient of 1.62×10-3, the separation area is reduced about 46%, and the aerodynamic performance of the S-duct is also greatly improved compared to uncontrolled case. Further analysis reveals that the choice of actuation frequency is mainly determined by the momentum flux produced by a single ejection and the spacing between adjacent ejections, the optimal frequency case can be understood as a balance between the two factors. In addition, it is found that the synthetic jets can also suppress the secondary flows while decreasing the separation.      

带气膜阻尼结构振动特性的理论研究

针对航空发动机气膜阻尼的结构设计需求,基于挤压间隙流理论和能量方程建立气膜阻尼的力学模型,由此获得气膜阻尼结构的等效刚度系数和等效阻尼系数,通过振动方程的理论推导获得放大因子的表达式.结果表明:气腔厚度、气腔初始压强、吸振薄板模态频率和安装位置是影响减振效果的关键参数.气腔最优厚度主要由附面层厚度和实际振动频率决定,需结合实际情况确定气腔厚度,以最大程度降低振动响应;气腔初始压强越高,阻尼系数越大;吸振薄板的固有频率应尽可能与叶片本体接近,并且安装在本体振动响应最大位置,以取得最好的减振效果.